Visual Land Impulse Betriebsanleitung PDF herunterladen (Seite 11)

CONTROL PANEL

1. TUNER/BATT TEST CONTROL: Tunes the detector

to its maximum sensitivity by adjusting the “threshold

level” to a faint tone. Also, when turned to BATT

TEST position, signals condition of batteries with

audio tone and LCD bar graph.

2. Liquid Crystal Display: LCD gives a continuous,

visual check of battery condition and provides a

visual display of signal strength. A bar graph rises

with an increase in signal strength and falls with a

decrease in signal strength. The bar graph also

indicates the approximate strength of the batteries

when the tuner is in the BATT TEST position. A full-

scale reading of the bar graph indicates fully

charged batteries, while just a few bars means the

batteries are getting low. And when there’s only a

couple or no bars remaining, it’s time to replace

the batteries. Also, at this point, “BATT OK” is

replaced by a flashing “LO BATT.”

NOTE: Always remove your headphones or turn

down the volume before clicking into the BATT TEST

position.

3. Light Emitting Diode: LED flashes red when a

target is detected or the batteries are being tested.

4. VOLUME CONTROL: Adjusts volume of audio

headphone signal. The OFF position turns detector off.

5. STEM MOUNT: Bottom of control housing slides

into mount on stem handle, providing easy

detachment of the control housing for hipmounting.

The IMPULSE offers the user three

different target signals: an audio

target response, a large LCD bar

graph and a bright, red LED.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Keine Kommentare

Visual Land Impulse Betriebsanleitung Seite 11